OTDR and jacket length markings are inconsistents

Why are OTDR and jacket length markings inconsistent? The answer depends on the type of fiber optic cable being made. There are now many different types of cable designs that defeat this assumption, although many such cables are still being manufactured and the length of the fiber beyond the jacket length is a function of core diameter (larger core/larger helix) .

central tube hypothesis

The first and most common assumption is that for a center tube design (which pulls all the fibers together), it is best if the length of the fiber and the length of the cable jacket are the same (i.e. , there is no difference between the length of the jacket and the fiber). In fact, in these types of cables, the fiber enclosures actually over-stretch the fibers, so there are many problems, and in fact, you may find that the fiber length is shorter than the jacket length.

This is a bad thing and usually happens on a fiber optic cable reel, where the fiber migrates inside the tube, thus creating a smaller circle. When unwound during installation, the optical fiber is often pulled back from the end of the cable or put under tension, so the service life may be shortened.

In addition, depending on the number of cables and the manufacturer, the indoor fiber can be stranded or unstranded. Again, it is critical to understand the type of cable design before measuring fibers and comparing results.

Mechanical and Digital Printing

Many mechanical printing systems, especially inkjet or laser jetting systems, rely on digital encoder signals to calibrate distances. Depending on the design of the line manufacturer, the configuration is different on each line. Major fiber optic cable specifications only require a mechanical measurement accuracy of 1%. These are generally considered adequate for most installations.

A second point about mechanical and digital printing on fiber jacketing is when in the process the printing is applied. Since jackets generally shrink as they cool, you must also estimate the shrinkage between the print and the final length if you place the print on the end of a hot water bath.

The third aspect of making water cloudy is the use of fibers that are not sensitive to bending. By using these fibers - which exhibit no appreciable loss until force is applied (bend radius, tension, microbending sensitivity, etc.) - these fibers can be elongated in a gel-filled central tube design, or loose tube Fiber bundles or ribbons of fibers that exhibit the correct length even under tensile tension. Typically, dry core designs do not exhibit these behaviors.

in conclusion

It depends on the design of the fiber, how the fiber was printed during manufacturing and whether it was filled with gel. Finally, one item not discussed here that is part of all OTDR training is this: You must have the correct index of refraction at the correct wavelength before making a measurement.