ADSS Optical Cable Fusion Precautions

In the process of installing the optical cable, it needs to go through the process of fusion splicing. Since the ADSS optical cable itself is extremely fragile, it is easy to be damaged even under a slight force. Therefore, it is necessary to complete this difficult work with great care and high requirements during the specific operation. In order to perfectly complete this task, relevant experts have concluded and found that there are three major points for attention in ADSS optical cable fusion splicing.

Three precautions for ADSS optical cable fusion

1. Pay attention to the preparation work before welding

In order to avoid electric shock, in particularly humid weather, if this work is carried out, grounding measures should be taken first. And the corresponding length should be calculated before welding the ADSS optical cable, and the side with heavier force should be cut off. In order to achieve better welding, the light should be set aside for a specified distance, and the length of the outer skin loosening magnetic tube should be determined according to the situation. At the same time, it is necessary to avoid the internal structure at night when broadcasting, so it must be well controlled The depth of the blade.

Second, attention should be carefully operated

When wiping, in order to avoid damaging the inside of the ADSS optical cable, do not wipe from the root of the end to avoid damaging the end, and avoid twisting the ADSS optical cable during any operation, otherwise it is easy to cause damage. It is also necessary to protect the eyes and skin of the operator at the same time, especially do not stare at the end face of the optical fiber when using the laser. After peeling off the surface layer, the optical fiber will stab the skin, so you need to be very careful when welding. Moreover, some waste materials cannot be disposed of casually, they should be collected and disposed of according to regulations.

3. Pay attention to take corresponding measures according to the weather conditions

In winter when the temperature is relatively low, in order not to be affected by the low temperature, genuine ADSS optical cable manufacturers remind that electric heaters should be used to increase the ambient temperature. It is best to wrap the fusion splicer with an electric blanket to increase its temperature. to make sure it works properly. If the weather is relatively humid, ADSS optical cable manufacturers suggest that moisture-proof measures should be taken, especially the heat-shrinkable tube should not be taken out in a hurry, it should be put in a bag, and it should be taken when it is used. At the same time, it should be noted that the construction should be stopped during the rainy season. of.

The above are the three precautions for ADSS optical cable fusion. In addition, it should be noted that the optical fiber should not touch anything before fusion, because dust pollution on the surface of the optical fiber may affect its use. Quality-assured ADSS optical cable manufacturers also reminded that when using or storing optical fibers, especially bare optical fiber connectors, it is necessary to concentrate on relevant protective measures, such as neatly discharging and handling them with care. Absolutely not It should also be properly fixed and protected.